Our Laser is 100W, and does an excellent job. Our kits are less expensive than some others as the more powerful laser can cut a lot quicker, with more accuracy.
Send us your plan, either paper or electronic, and we will generate all the parts in Autocad and cut the kit for you. If you want a model scaled up or down we can do that as well. The cost for scaling up or down will be a little bit higher, but not excessive. We are aiming to keep the cost as low as possible. If you can send us a DXF file the cost of cutting the kit is significantly reduced.
Plywood thicknesses we have in stock are.
Basswood 5 ply, 3mm,
Birch 3 ply 4mm and 5 ply 6mm
Birch Aircraft ply 0.4mm, 0.8mm, 1.0mm, 1.2mm, 1.5mm, 2mm, 2.5mm, 3mm
All laser cut kits are short kits and only include all formers and ribs, no sheeting, spars, cowls, canopies, wheel pants, fittings, fuel tank or wing tubes unless otherwise stated